Engineering & Technical Division

私たちのブログを訪問していただきありがとうございます。あなたがお持ちの場合DIYの要求は私達に電子メールを送信してください。



This is the new Scar-h from Tokyo Marui. Is this post I will show you basic takedown of the Scar-h to get into the gearbox.
I will also show the simplest way to disable the full auto of the gun. (New Zealand law on airsoft is that all guns must only be on semi-auto), we are shipping this gun to New Zealand.



Takedown

First remove these two screws including the one in the middle


Then on the end of the rail remove this screw. You might need to remove the rear sight or just loosen it and slide it.


Then these two screws (both sides)


In removing the upper asembly just slide it towards the front


Then fold the buttstock...


...and remove these two screws


Separate the power connectors...


Unlike here it is still connected (my first time to open up a Scar)


Now just remove the motor M4 style


After removing the motor slide this pin out and then you can safely slide the gearbox out


Just showing the mechanism that makes this gun ambidextrous


Now takedown is done


Semi-Auto Modification

Our first thought of Semi-auto mod is to block the selector plate into going full auto. But our master techs showed us a way to do it without blocking the function the selector lever. it involves modding the selector plate to disable the cut-off lever into going full auto.

Here is the selector plate


We will remove the part in red...


...this part when pushed back (full-auto mode) will lift and disable the cutoff lever thereby the continuous flow of current and full auto


Dremmeling


Finished and installed. This mod will not only disable the full-auto but the player can still push the selector lever into full auto but still get semi-auto.










NEWS ARCHIVES